Continuous power versus peak power
A battery spec sheet usually gives two power figures in kilowatts. Continuous power is what the battery can supply steadily. Peak power is a higher figure it can supply only briefly.
Continuous power
One glossary defines continuous power as the constant amount of power a battery can discharge over a prolonged period.1
This is the figure to compare with the loads that run together. If you plan to run many power-hungry appliances at the same time, the glossary says you need a battery with a higher continuous rating.1
Peak power
Peak power goes by other names on sheets: surge, maximum, or short-term power. The glossary calls it max power. It's the absolute maximum power a battery can discharge over a short burst.1
The glossary also says the continuous figure will always be lower than the max figure.1 So if you see the same number in both places on a sheet, look for a footnote.
How long can the peak last?
The glossary describes the peak as typically measured over several seconds to several minutes.1 That's a wide range, and it's a general description, not a promise about any one product.
The actual duration is a separate line, or a footnote, on the maker's own spec sheet. Look beside the peak figure and in the small print. If it isn't there, don't assume. Ask the maker or the installer, and ask for the answer in writing.
Here's how to read the pair of numbers.
- Find the continuous kW rating. Treat it as the ceiling for your everyday load.
- Find the peak kW rating. Treat it as a short-term allowance only.
- Find how long the peak is allowed to last. This might be written in seconds.
- Check whether the peak figure depends on conditions, such as temperature or charge level. The sheet's footnotes should say.
- Check whether the ratings are stated for backup use. If the sheet doesn't say, ask the maker.
Why the peak matters at all
Some devices draw much more power for a moment when they start. A motor is the usual example. The inrush current article describes how alternating-current motors and transformers may draw several times their normal full-load current when first energized, for a few cycles of the input waveform.2
The same article defines inrush, or surge, as the maximal instantaneous input current drawn by a device when first turned on.2 A battery's peak rating exists partly to ride through those moments. The glossary gives a sump pump as an example, since its power requirement spikes when you turn it on.1
The next page, surge loads and motor starting current, covers where to find that start-up figure for your own appliances.
Common mix-ups
- Peak is not extra capacity. It's a higher rate for a short time. It doesn't add kWh. See kW and kWh.
- Continuous is not unlimited. A battery can still run empty. Its stored energy sets how long it can supply any steady load.
- Names vary. Two sheets may call the same idea "rated," "nominal," "maximum" or "surge." Read the definition, not only the label.
- Sums matter. The continuous figure applies to the total of everything running, not to each appliance separately.
Who does the sizing
Matching a battery's ratings to your home's circuits is a job for a licensed electrician or a qualified installer. Don't wire a battery, a switchboard or a transfer switch yourself, and don't try to feed a home through an outlet. Follow your own product's manual and local rules.
Reference list
- Speak storage fluently with these key terms, EnergySage
- Inrush current, Wikipedia